What kind of line do you use on a baitcaster?
Baitcasting reels are used for more heavy or reaction-strike applications. You can use line anywhere from 10 to 25 lb monofilament or fluorocarbon, and 30 to 80 lb braid. Here is a quick rundown of which line to use for which baits.
How much line should be on a baitcaster?
The general consensus says to put enough line on your reel until there’s a 1/8 inch gap between the line and the top of the spool. You don’t want to fill it up completely because you’ll never really use all of it and you don’t want to fill it halfway because it didn’t seem to cast as well.
Is mono or braid better for Baitcasters?
Take a wrap past the leader with braid, and you could lose a finger if a big fish struggles boat-side. Mono holds knots better and costs less than braid. It also works better on smaller bait-casting reels because light braid can dig into itself.
Why is Baitcaster better than spinning?
Baitcast reels can handle heavier line and actually allow for longer casts than spinning gear in the same size range. … A small spinning reel has a smaller, more narrow spool, which has a hard time with large diameter lines. Small baitcast reels can handle these lines and provide greater casting distance.
Does color of fishing line matter?
In short, certain colors of braided fishing line are more visible in certain water conditions but it won’t make a difference because you’ll be attaching a clear fluorocarbon or monofilament leader. In almost all cases, the fish will never see your braided line and that’s why the color doesn’t really matter.
Do you need to soak fishing line before spooling?
Always prior to spooling up with mono, leave your line submerged in a bucket of water. … Usually a few hours soaking time will do but I tend to leave mine soaking overnight with the use of a heavy lead to ensure the whole spool of line is under the water. Tension. There’s nothing worse then loosely wound line.
Why does my fishing line unravel?
Most of the time, improper use of equipment is the culprit for unraveling fishing lines. So, here are some ways to fix and prevent this problem from happening. Avoid overfilling your reel’s spool. Compressing is one of the most causes of unraveling fishing line.
Is 150 yards enough fishing line?
150 yards should be plenty of line. If you get spooled with 150 yards of line on, the problem is not the amount of line you have but that you do’t have enough drag capability. You shouldn’t need to leave 30 yards of line on. 5 to 10 should be plenty or put one turn of electrical tape directly on the spool.
What happens if you put too heavy line on a reel?
Heavier monofilament and fluorocarbon lines do not perform well on spinning reels because the diameter of the line is large enough that the spooled line will jump off the reel spool when casting. …
Can you put too much line on a baitcaster?
Casting reels should be between an eighth of an inch from the top and all the way to the top. … Spinning reels should be all the way full, right to the top. If you get too much line on them, the line will jump off the spool in coils. You can stop backlashes with baitcasters by adjusting your reels properly.